D'Link Firmware Update It With

If you have concerns running the Firmware Update tool after re-start, please click here for further help.

As for mass erasing, I forgot to include that it did erase the chip as everything is Zerod out and the flash size is Unknown but it gave the readout protection during erase and is still giving the error.

Any specific BIN file name Or a requirement other than copying to the card root.

Im clueless. Installation instructions absolutely useless:-(.

Search for readable strings containing.bin and.cur.

And youll get the right name- completely without guessing.

It just says that calibration failed and starts the calibration sequence again.

It doesnt matter if I use the precompiled or if I compile it myself.

I have tried several different filenames including the ones suggested in this thread.

I bought two of these displays and it is the same problem with both.

Can I do it with an Arduino Uno Dont laugh, im a really noob.

D'Link Firmware Update It With

Because from what I understand were supposed to update it with sd card (thats what your GitHub says) and not via stlink.

I think the feedback of the sd card presence pin interfere with the upload.

Seems that my tft35 v2.0 is bricked.

I got a new board and assumed that the bootloader was broken without checking if the bootloader was updated.

I followed BIQUs instruction on updating the bootloader using a ttl, btts instruction and a hex file.

It successfully wrote but then I got an illegal error and a white screen ever since.

It seems that I cant read from the uart ports anymore but I figured out the ST Link method.

Is possible to write protect a board and if it is, why would BIQU do this If its write protected how was I able to ruin it via the UART port but cant reprogram Thanks.

You need to unlock it, using the ST-link and the appropriate utility.

I use the J-link, that does this automatically, so I dont know how its done with the stlink.

Do a web search. Also, when programming fails, you should try several times before giving up.

Then write the boot loader as described and you are good to go.

D'Link Update Firmware